Started putting the engine back together today.  Made good progress until I went to tighten down the cam cover & was torquing the 1st bolt with my torque wrench.  Broke the bolt  … in the hole with the cover on and all other screws hand tightened.  New gasket installed with gasket tack.  Great.  Get to take it all the screws out tomorrow (just from the cam cover), buy an extractor set, and hope the gasket is quite reusable.

In better news it will be on to the carburetor after that.  hopefully later this week I can try putting it on & seeing if it starts again.  Without breaking any more bolts.